Vaping is a cooler and much safer option than smoking cigarettes. Science shows that vaping eliminates a good chunk of the health risks associated with smoking. It also helps control nicotine addiction and quit cigarettes for good.
The switch to vaping can be a breath of fresh air, no pun intended. However, learning how to vape well can take time. As you advance to more powerful devices such as vape mods and e-shishas, you will experience a burnt taste from vape.
In this article, we look at what causes it and how to fix a burnt coil.
What Causes the Burnt Taste?
Before we delve into how to fix a burnt coil, the first question you may have is what causes the burnt taste? In most cases, experienced vapers will say that you have a burnt coil. However, the more precise answer is that the cotton or wick wrapped around the coils is charred.
The charred wick can happen because of different reasons. The most common issue is vaping at a high wattage. Another problem is vaping while the tank is too low. This often leaves the wick exposed when vaping.
The last issue that can cause your wick to get burnt is not giving the coil enough time to get primed. This means that you didn’t let the wick soak in the e-juice before switching on the vape. This means that when you fire up the vape, the wick is still dry, causing it to burn.
Steps on How to Fix a Burnt Coil
Fixing a burnt coil is easier and will save you from the hassle of buying a new replacement. If you get any hints of a burnt taste from the vape, take the atomizer and tank out and inspect the coil. Check if any spots are charred.
If there are any charred or blackened spots on the coil, the next step is to clean it. Detach the coil from the atomizer and use warm water and a soft brush to scrub the soot. Take your time to ensure that you clean away any residue that may be stuck on the coil.
After that, the next step is to dry-burn the coil. This can be dangerous, so be cautious to avoid hurting yourself. Reattach the coil to the atomizer and switch on the device for some time until the coil turns red hot. Blow on the coil while it is still red hot, and this will help remove remaining residue from the coil.
Now, it is time to prime the coil. Ensure that the tank is full and apply a few drops of e-juice on the wick to ensure that it is saturated. However, if you’re not in a hurry, let the pen sit for a few minutes before switching it on.
Wrapping Up
The last step is to test the coil. Switch it on and take a few puffs. If you still get hints of vape burnt taste, chances are that the coil may still have some residue or it is not well primed. However, if the issue persists after cleaning it multiple times, consider getting a replacement.
